BELIMED CS 720, Service Manual, Page: 26 / 62

Upon a door fault during closing the respective door is set to open. Upon fault during
opening, the respective door is de-energized. A de-energized door can be pushed open by
hand.
6.5 Program Selection
After a cart has been loaded, the user must select a program on the display screen. Once a
program has been selected, the process control will continue to use the program until a new
program is selected. After selecting a program, the user then presses the cycle start button to
begin the cycle
6.5.1 Factory Pre-set Programs
The Belimed CS 720 is shipped with three factory-selected programs. Each program is
adjustable by the user (requires service password) at the control panel. Programs are
adjusted by changing the number of repetitions in the wash and rinse cycles and aby
adjusting the time for the dry cycle. Table 6-1 shows the cycle values or repetitions of the
factory programs. Table 6-2 has been provided so the user can keep record of any mofified
programs.
Table 6-1:
Prog. # Program
Name
# of Wash
Cycle
Repetitions
# of Rinse
Cycle
Repetitions
Dry Time Recommended Load
1 Normal 1 2 145 sec Normally soiled carts
2 Light 1 1 145 sec Medium soiled carts
3 Heavy 2 2 145 sec Heavily soiled carts
6.5.2 User Defined Settings
Use this table to enter any adjustments to factory settings and retain for your records.
Table 6-2:
Prog. # Program
Name
# of Wash
Cycle
Repetitions
# of Rinse
Cycle
Repetitions
Dry
Time
Recommended Load
1
2
3
CS 720 Service Manual Revision 1.1 Page 18