2. Plug in the power cord, you should hear the beep sound from
Box A & B. Clear the program on Control Box A & Control Box B.
To clear the program, press the black button on the side of
Control Box A for 3 seconds, when you hear the beep sound
follow the same procedure to clear the program for Control Box
B.
3. Place remote A close to the "Remote Pairing" area on Control
Box A. When you hear the "Beep" sound from Control Box A,
press the "Head Up" or "Foot Up" button. If both bases are
working properly, your beds are properly synched and will work
with one remote.
REMOTE FEATURE
The Adjustable Bed uses a RF (Radio Frequency) hand control system.
NOTE: This bed may show minor intermittent performance because of typical RF
interference. This is normal in the operation of the bed, not a defect.
1. The buttons are backlit when pressed, to aid in the visibility of the remote in low light
environments.
2. It is not necessary to face the receiver to operate the remote control. Remote signal is
best transmitted within 9 feet (3 meters) of the receiver
TROUBLESHOOTING
Provided are a list of possible symptoms and their solutions should the adjustable base fail to
operate properly
Symptoms
Solutions
The base does not respond when the
remote is used.
Remote LED illuminates and appears
to be normal.
Perform any or all of the following:
1. Check that the power cord is plugged into a
working and grounded electrical outlet.
2. Check that the light on the control box is on
3. Check the home’s circuit breaker and fuses.
4. Unplug the power cord from the outlet. After
one minute, plug it back in. Press any button
on the remote. The base should be working.
The remote does not work or light up. Check the remote LED Light is lighting up when
pressed.
If not, please replace 2*1.5V AAA batteries.
