8
First steps
Twist 608 / Belgacom EN / A31008-M1905-E151-1-2M19 / starting_PTT.fm / 14.10.08
Ve
rs
ion 4,
16
.09.
2005
Attaching the belt clip
There are notches for attaching the belt
clip on the side of the handset at the same
height as the display.
¤
Press the belt clip onto the back of the
handset so that the protrusions on the
belt clip engage with the notches.
Opening the battery cover
¤
Place your fingertip in the cavity on the
casing and pull the battery cover
upwards.
Placing the handset in the base station
and registering
¤
Place the handset in the base station
with its
display facing upwards
.
The handset registers automatically.
Registration can take up to 5 minutes.
While this is happening,
Regstr.Procedure
appears in the display and the name of the
base station flashes. The handset is
assigned the lowest available internal
number (1-6).
This will appear in the display when regis-
tration is complete, e.g.
INT 1
. This means
that the number 1 has been assigned.
If the internal numbers 1–6 are already
assigned to other devices, the number 6 is
overwritten.
To charge the batteries, leave the handset
in the base station.
For questions and problems see page 41.
Headset socket
You can connect various headset types
(with 2.5 mm jack connector).
Initial charging and discharging of
batteries
If the handset is activated, the flashing
battery icon
e
in the top right of the dis-
play indicates that the batteries are being
charged.
During handset operation, the battery
icon indicates the charge status of the bat-
teries (page 1). The correct charge level
can only be displayed if the batteries are
first fully charged
and
discharged.
¤
To do this, leave the handset in the
base station or charging cradle
with-
out interruption
for
five
hours.
¤
Afterwards, remove the handset from
the base station and do not put it back
again until the batteries are fully dis-
charged.
Please note:
– Automatic registration is only possible
while no one is making calls using the base
station.
– Each key press interrupts the automatic
registration.
– If automatic registration does not work the
handset will have to be registered manually
– You can change the name of the handset
Please note:
– The handset will automatically switch on if
it is placed in the base station.
– Only place the handset in the base station
or charging cradle that is intended for it.
