BELGACOM TWIST 508, User Manual

Page: 62 / 66

58
Care and Maintenance
Use a slightly damp cloth to wipe the base and handset, do not use a dry cloth as this may
cause electrostatic charges.
Problems
Refer to the table presented below in case of an operational malfunction:
Problems Remedies
The handset display is blank Make sure the batteries are properly installed.
Place the handset on the base and fully charge the batteries.
As time goes by, you may notice a slight decrease in battery performance. Use
your handset until the battery is fully discharged, and then charge it for at least
6 hours.
If these precautionary measures do not resolve this issue, replacement
batteries are available from Belgacom.
The handset does not ring
during an incoming call Make sure that the telephone is properly connected and that you have a dial
tone.
Make sure your telephone is not set to silent mode (see chapter entitled Ring
Tones).
No radio link between the
handset and base
The network indicator icon
flashes Make sure the handset is registered by moving closer to the base, if it is
registered correctly, the handset screen should display its own handset number.
Otherwise, register the handset to the base. See “Personnal registering”,
page 51.
You obtain a "busy" dial tone for
each dialed number Make sure no one else is using another handset (if the intrusion mode is
desactivated).
Make sure that the dial mode (tone or pulse dialing) is compatible with your
telephone line or your automatic branch exchange.
Make sure your time limit has not run out (if activated).
Make sure you are not on call restriction (if activated)
You cannot send or receive
SMSs Make sure you have subscribed to a caller display service.
Contact Belgacom to check if the SMS service is activated on your line.
Make sure that the server number is 1976 for transmissions and 01976 for
reception.
Have you provided your contacts with the right terminal number?
A
PPENDIX