FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation. NOTE 1: This equipment has been tested
and found to comply with the limits for a Class B digital device , pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
NOTE 2: Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate
the equipment.
Warning! : The portable radio generates RF
- electromagnetic energy during transmit
- mode. This radio is designed for and
- classified as “Occupational Use Only,”
- meaning it must be used only during the
- course of employment by individuals aware
- of the hazards and the ways to minimize such
- hazards. This radio is NOT intended for use
- by the “General Population” in an
- uncontrolled environment.
- The device complies with RF specifications
- when the device used at 25 mm from your
- front face and 0mm from your body, SAR
- compliance for body-worn operating
- configurations is limited to the specific belt
- clip/ holster/accessories tested for this
- product.
- Body-worn accessories that do not meet these
- requirements may not comply with RF
- exposure requirements and should be
- avoided. Maximum SAR Value (1g): 0.699W/Kg.
Summary of Contents for BF-TD300
Page 1: ...1 TD300 Service Manual ...
