Belden Miranda NV9640A, User Manual

Page: 49 / 112

39
NV9640A
User’s Guide
How to Configure MD Destinations
Follow these guidelines.
1 Click any line in the display. (A single click is all that is required.) A dialog appears. This is the
multi-destination entry editor:
On the left is a list of all destinations defined in the NV9000 system. On the right is a table of
the MD destinations you are defining. The number of rows in this table is equal to the maxi-
mum number of MD destinations your configuration allows.
To define an MD destination, select a destination on the left and copy it, using either the
‘Append’ button, the ‘Insert’ button, or the ‘Replace’ button, to the right.
The ‘Append’ button appends the selected destination to the end of your set of MD destina-
tions.
The ‘Insert’ button places the selected destination immediately above whatever MD destina-
tion you have highlighted on the right.
The ‘Replace’ button replaces whatever MD destination you have highlighted on the
right.with the selected destination from the left.
The ‘Remove’ button removes highlighted MD destinations from the right.
At the bottom left, there is a scroll box in which you can adjust the maximum number of MD
destinations. (The page size is indicated as fixed at 8 entries. You cannot change the page
size.)
At the bottom right, are ‘Move Up’ and ‘Move Down’ buttons. You can use these to adjust the
position in the list of any MD destination.
After you have finished configuring MD destinations, click OK (or cancel, if you want to dis-
card your entries). The MD destinations you have configured now appear in the display sec-
tion of the panel graphic. They will subsequently appear in the display of the panel when it is
operating in MD mode.
You can edit the set of MD destinations later, adding or removing entries as you wish.