6.5 Removing from the DIN Rail
The DIN rail clip is suitable for a DIN rail according to EN 60715 standard only. The default
position of metal rail clip, which is used for mounting the router on a DIN rail, is shown in the
following figure. Its position can be changed on some models (back or bottom). When changing
the position of the DIN rail clip, tighten the screws with max. 0.4 Nm torque.
Figure 8: Default position of DIN rail clip
To remove the router from the DIN rail it is necessary to lightly push down the router so that
the bottom part of the DIN rail clip hitched to the DIN rail get out of this rail and then fold out the
bottom part of the router away from the DIN rail.
Figure 9: Removing from the DIN rail
22
UM Installation OWL LPWAN
Release 02 - 02/2020
