Belden Grass Valley NV9603, User Manual

Page: 18 / 67

8
Installation
Installation
Installation
Follow these steps to install a NV9603 control panel:
1 Mount, and secure, the panel in the rack.
The NV9603 is designed to mount in a standard 19
©
rack. Rack-mounting is not a
requirement.
2 We assume that you have an Ethernet switch connected to the “Panel and Router
Network” port of your system controller. Connect an Ethernet cable from that switch to
the RJ-45 port at the rear of the NV9603.
3 Connect power.
Installing Software and Documentation
This document is available through the Grass Valley web site.
You must use NV9000-SE Utilities to configure the NV9603 control panel. Contact Grass
Valley if you need to obtain the latest version of this NV9000 configuration software.
You may use the Panel IP Configuration Utility if you want to your NV9603 to have a static IP
address (with respect to the system controller) or to use DHCP. The panel, as it comes from
the factory, defaults to DHCP.
Initialization
Before your system controller can communicate with an NV9603, you must give it a panel
ID. Follow these steps for each NV9603 you are installing:
1 Power up the NV9603. Do
not
connect its Ethernet cable. (Disconnect it if it is
connected.)
After a few seconds, the display will show ‘ACQ IP’ at the top and show the panel’s
current panel ID. The top right button is high-tally green:
We call that the “setup” button while the panel is disconnected from the network.
2 Press the setup button. The panel now allows you to enter the panel ID using buttons at
the left that function as a numeric keypad. The numbers of the keypad a printed on the
panel. They range from 0 (at the left) to 9:
Enter the panel ID using the keypad. Then press the setup button again.
A C Q I P
0
Setup
button
P a n e l I D
1 2 3