Belden Grass Valley Kaleido-Modular-X, Hardware Description & Installation Manual

Page: 43 / 96

43
Kaleido-Modular-X
Hardware Description & Installation Manual
To replace a rear connector panel in a Densité 3+ FR1 frame
1 If a card is already installed in a slot covered by the rear panel you wish to change,
remove it (see Removing a card , on page 43).
2 Remove the existing panel by releasing the captive screw.
3 Position the new panel and secure it in place with the captive screw.
Removing a card
To remove a card
1 Open the front door of the frame (see Opening the front door , on page 40).
2 Tilt the swivel handle, on the front of the card you wish to remove, to lever the
connectors apart, and then use the handle to pull the card straight out of the slot.
3 Close the front door of the frame (see Closing the front door , on page 41).
Note:
Removing more than one input card from a Kaleido-Modular-X
system in operation is not supported.