Belden GRASS VALLEY HDA-3961, Manual To Installation And Operation

Page: 8 / 25

GUIDE TO INSTALLATION AND OPERATION
8 | HDA-3961

SFP-U-R-LC 12G Single RX Fiber with LC/PC

SFP-U-RR-LC 12G Dual Rx Fiber with LC/PC

SFP-U-RT-S13-LC 12G Dual Rx/Tx Fiber 1310 nm with LC/PC

SFP-U-T-S13-LC 12G Single Tx Fiber 1310 nm with LC/PC

SFP-U-TT-S13S13-LC 12G Dual Tx Fiber 1310 nm with LC/PC

SFP-R-LC Single fiber RX cartridge with LC/PC connector

SFP-RR-LC Dual fiber Rx cartridge with LC/PC connector

SFP-T-S13-LC Single fiber TX cartridge at 1310 nm with LC/PC connector

SFP-TT-S13S13-LC Dual fiber Tx cartridge at 1310 nm with LC/PC connector

SFP-RT-S13-LC Dual fiber Rx/Tx cartridge 1310 nm with LC/PC connector
Note: The HDA-3961 can also make use of SFP optical plug-in cartridges from the WDM and CWDM series. Other
types of SFP optical plug-in cartridges may be available
.
Insert the appropriate cartridge for your application into the Fiber I/O connector, and then connect the fibers to the
cartridge via the LC connectors.

See ANNEX 2 on page 23 for a detailed description of the installation & removal procedure.
3
Operation
3.1 Control Options
The HDA-3961 can be controlled in two different ways:

The local control panel and its push-buttons can be used to move through a menu of parameters and to adjust
parameter values (see section 4).

Grass Valley
’s iControl system can be used to access the card’s operating parameters from a remote computer,
using a convenient graphical user interface (GUI). (see section 5)
3.2 Card-Edge Status LED
The status monitor LED is located on the front card-edge of the HDA-3961, and is visible through the front access door
of the DENSITÉ 3 frame. This multi-color LED indicates the status of the HDA-3961 by color, and by flashing/steady
illumination.
The chart shows how the various error conditions that can be flagged on the HDA-3961 affect the LED status.

If a cell is gray, the error condition cannot cause the LED to assume that status

If more than one LED status is possible for a particular error condition, the status is configurable.
See Section 5.6 for details.

The factory default status is shown by a

The LED will always show the most severe detected error status that it is configured to display, and in the chart error
severity increases from left to right, with green representing no error/disabled, and flashing red the most severe error.