GUIDE TO INSTALLATION AND OPERATION
HDA-3961 |
9
LED Status
Error Condition
Green
Yellow
Red
Flashing
Red
No input signal presence
No lock on input signal
No rear
: Factory default.
If the LED is Flashing Yellow, it means that the card is selected for local control using the Densité
frame’s control
panel. See Section 4 for details.
The LED will be Yellow when the card is in the “Firmware Update” mode.
4
Local Control Using the Frame’s Control Panel
Push the SELECT button on the HDA-3961 card edge (see Section 1.4) to assign the local control panel to operate
the HDA-3961.
The STATUS LED on the HDA-3961 card edge flashes yellow.
Use the control panel buttons to navigate through the menu, as described below.
The complete menu structure is shown in
– HDA-3961 Local User Interface
on page 22.
Two versions of the local control panel exist:
Panel type
Frame models
Appearance
Physical
Densité-2, Densité-3, Densité-
3+FR1,
Touch screen
Densité 3+FR4, GV Node
The local control panel is fastened to the
front of the frame’s controller card.
The physical panel is accessed by opening the front door of the frame.
The touch screen panel is accessed through an aperture in the frame door.
The panel incorporates a display capable of displaying two lines of text, each 16 characters in length, and four
pushbuttons. The functionality of the pushbuttons is as follows:
[+] [
–]
Used for menu navigation and value modification
HDA-3961
