Belar FMHD-1, Operator'S Manual

Page: 52 / 58

FMHD-1 Operator’s Manual
Page 44 FMHD-1
Popup
Heading Selections Popup Options
Settings Network Network
Status
MAC: 00:20:4a:d5:37:9a
(sample address)
Host:
IP Addr: xxx.xxx.xxx.xxx
Subnet: 255.255.255. 0
Gateway: xxx.xxx.xxx.xxx
DHCP:
ON (The three addresses
above are to indicate their
form only.)
OFF
(Addresses are fixed.)
Refresh
(Depress encoder knob to
refresh readout.)
Network Network
Configure
IP Addr: xxx.xxx.xxx.xxx
Subnet 255.255.255. 0
Gateway xxx.xxx.xxx.xxx
DHCP:
ON (All three addresses above
default to “
<DHCP>
”.)
OFF
(The addresses are
entered manually.)
Apply (Depress encoder knob to
apply settings.)
Status:
“ IDLE ” or “ ACTIVE ”
(read-only)
Settings Email (The entries below are present in each of the four alarm messages,
Email #1
through
Email #4.)
TO: [An SMTP address of a series of 94 possible
characters, 24 characters in length.]
CC:
[An SMTP address of a series of 94 possible
characters, 24 characters in length.]
FROM: [An SMTP address of a series of 94 possible
characters, 24 characters in length.]
SUBJECT:
[A series of 12 characters which form the alarm
message.]
TEST: Placing the cursor on “
TEST
” and depressing the
knob sends the message to test its operation without
an alarm actually occurring.