FULL SIDE WASHER
30
Belanger, Inc. * PO BOX 5470 * Northville, MI 48167-5470 * Ph (248) 349-7010 * Fax (248) 380-9681
1MANUL854
Installation
Neo-Tex Cleaning Material
Upper Hub
1) Mount the t
wo 6” diameter x 42-1/2” tall hubs so that they set on top of
the
lower hubs by securing the “Spider” Clamps to the shafts and
se
curing the “Skins” to the Spiders as shown. Be sure that the open
ends of the “C” channels are facing upward (FIGURE 1).
2) Locate the 41
” x 8” Neo-Tex pieces that are 1/4” thick (thicker Neo-
Tex material). Fold them in half and place one in the first, middle, and
last slot of each skin of the hub, making sure they are pushed all the
way to the bottom (FIGURE 2).
3)
Locate the 25” x 8” Neo-Tex pieces that are 1/8” thick (thinner Neo-
Tex material). Load
two
pieces onto each 8” clip to provide the fill for
this row. Place 12 of these assemblies into the previous slots filled to
continue stacking the upper hub.
4) Locate
the 25” x 8” Neo-Tex pieces that are 1/4” thick (thicker Neo-
Tex material). Load
one
pi
ece onto each 8” clip to provide the fill for
this row. Place 12 of these assemblies into the previous slots filled to
continue stacking the upper hub.
5) Locate the 28
” x 8” Neo-Tex pieces that are 1/4" thick (thicker Neo-
Tex material). Load
one
piece onto e
ach 8” clip to provide the fill for
this row. Place 12 of these assemblies into the previous slots filled to
continue stacking the upper hub.
6)
Locate the 32” x 10” Neo-Tex pieces that are 1/4" thick (thicker Neo-
Tex material) Load
one
piece onto each 10” clip to provide the fill for
this row. Place 12 of these assemblies into the previous slots filled to
continue stacking the upper hub.
Top Row 32” x 10”
Insert into on
e 10” clip
.
First, middle
and last slot
of a skin
Upper Hub
(Top view)
FIGURE 2
FIGURE 3
FIGURE 1
