June 30, 2006
Confidential
Document Number BDTM10001-A05 Standard
BelAir100 User Guide
Common Radio Module Configuration Commands
Common Radio Module Configuration Commands
This chapter describes how to display and configure radio parameters that are
common to both access radios and backhaul radios, including:
• “Radio Mode or Disabling a Radio” on page 35
• “Transmission Power Level” on page 38
• “Dynamic Frequency Selection” on page 39
All CLI commands described in this chapter are available in
radio
mode.
To configure parameters that are specific to access radios, see “Access Radio
Configuration” on page 40.
To configure parameters that are specific to backhaul radios, including the
different types of backhaul links, see “Backhaul Link Configuration” on page 46.
Other aspects of radio configuration and operation are described in:
• “Wireless Security” on page 59
• “Managing Access Radio SSIDs” on page 76
For full details on radio module configuration, see the
BelAir100 Radio
Command Line Interface Guide.
Displaying the
Radio
Configuration
You can display the configured parameters of a radio module using
radio
mode
show
commands.
The following show commands are the ones used most often:
show {arm<n>|brm<n>} config
show brm<n> status
show {arm<n>|brm<n>} mac-address
show {arm<n>|brm<n>} mac configuration
The following sections describes each of these commands in more detail.
Displaying All
Configuration
Parameters
show {arm<n>|brm<n>} config
This command displays the configuration of a radio.
