Bel Canto e.One series C7R, User Manual

Page: 12 / 15

Using Headphones
When headphones are inserted into the headphone jack, the volume can be adjusted via the control knob or remote. The
input can be selected as normal from the front panel or remote. The Loudspeaker and Line Outputs of the C7
R
are disabled
when headphones are connected.
Power Up
We recommend leaving the C7
R
powered at all times as the sonic quality is best after several hundred hours of play and 48-72
hours of power on after the initial break-in time.
Connection to a Computer
The USB port can be used for up to 24/96 data, enough for any CD source. For more details on optimizing computer audio
sources please refer to our on-line guide at: www.belcantodesign.com
What to do if there is hum or ground noise
The design of the C7
R
greatly reduces the chance for ground loop induced hum and noise. Connect all power cables of the
audio system to a common outlet box or power conditioner unit. Having the audio system components share a common
ground will greatly reduce the possibility for ground current noise being introduced into the audio signal path.
Volume Control Punch Through
The Volume Up, Down and Mute functions on the remote control will affect any Bel Canto unit in Variable Output mode
regardless of whether PRE, DAC, CD or TUNER is selected. It is recommended that only the device with volume control
closest to the power amps be in Variable Output mode. Any other devices that are capable of volume control should be in
Fixed Volume mode.
The quality of your FM Antenna and the location and connection of the antenna are critical to the quality of the audio that you
will get from any FM tuner. The supplied antenna wire is only intended as a quick way to check the correct hookup and
operation of the FM1 but should NOT be used for critical evaluation of the FM1 performance.
It is important that you work
with your dealer in choosing and setting up the correct 75 ohm FM antenna for your reception area and needs.
There are 3 points to pay attention to:
1) Choose the best FM only antenna that you can afford and accommodate in your location. Good results can be had
in urban areas using a directional indoor antenna but in rural areas were station strength may be low it could well be
necessary to install a good quality Yagi directional antenna that is sited to receive your favorite radio stations. There
are many sources of good FM antennas for example: http://www.fmdxantenna.com has a good selection of both
indoor and outdoor antennas that should work well. Beware of the cheap ‘active’ gain antennas from various sources
as they often just add noise and distortion to the signal and do not really improve reception.
2) Use the correct 75 ohm coaxial cabling to connect from the antenna to the FM1. RG6 type coax is the best for
cable runs over 75-100 feet while RG59/U type cable can be used for shorter runs. In any case make sure that the
terminations and connections are clean and tight for reliable operation.
3) Any outdoor antenna should be installed by a professional to make sure that the correct safety precautions are
taken to protect you and your equipment.