Never Connect Either the Positive or Negative Speaker Output to Any Ground Contact!
Use Class 2 Wiring for all Loudspeaker Connections!
Beginning in the upper left:
•
ON/OFF switch applies power when the switch is
in the 1 position.
•
Fuse Drawer with 5 amp/250V slow blow 5mm x
20mm fuse.
•
IEC power cord jack: Connect the supplied or a
quality aftermarket power cord from this jack.
Note the power setting indicated on the back of
the unit before connecting the power.
•
GND:
Ground wire attachment for turntable
.
•
Antennae:
75 ohm coaxial F-type antenna
connection
(Read p. 11 regarding your antenna)
•
Line Out
: A volume controlled line output that
can be used to drive a second amplifier or
powered subwoofer.
•
Line In
: For signals up to 2.5Vrms.
•
Phono:
Preamp input raises MM cartridge signal
to line level.
•
USB:
Digital input can be connected to a
computer for playback of any audio format up to
a 24/96 data rate. The system will automatically
recognize the C7
R
as an audio converter
enumerated as
Bel Canto USB 2496
when using
Windows 98 or later and any version of
Macintosh OSX.
•
IR In:
Connect a 38 kHz IR extension emitter to
increase range of the remote.
•
TOSLINK 2
and
TOSLINK 1
: Digital inputs
accept any standard plastic or glass fiber optical
TOSLINK cable and operate to 24/192 data rate.
•
SPDIF2
and
SPDIF1:
Digital inputs accept RCA
connections from any 75 ohm SPDIF source and
operate up to and including a 24/192 data rate .
•
R +/- and L +/-:
Loudspeaker binding post
connectors.
When all connections to and from the unit have been made then double check everything before plugging the C7
R
into the
power source. After turning on, the C7
R
will go through its display check and show the software revision number. The unit will
be in Soft Mute with the SP1 input selected. The volume will be set to 50.0.
The sonic performance of the C7
R
will begin to stabilize after 100 hours of continuous power up.
Summary of Contents for e.One series C7R
Page 1: ......
Page 15: ...version 2 0 ...
