4.1 Setup
VS
During installation, when you power on the product for the first time, the calibration
mode* must be started.
Calibration mode allows the machine to correctly detect the amount of laundry loaded. To
activate the calibration mode, the Drum Clean** program must be selected and the spin speed
option must be cancelled.
During the cycle, the drum must be empty.
It takes about 15 minutes. To end calibration mode, the program must be run to
completion.
* Calibration mode may not be available for all models.
* * The name of the program may change depending on the models. You can check the
explanation part of the program to choose the correct program.
• Contact the nearest Authorized Service Agent for installation of your product.
• Preparing the location and electrical, water tap and sewage facilities
at the installation site is the responsibility of the customer.
• Check that the water inlet and drain hoses, as well as the power cable, are
not bent, pinched, or crushed when pushing the product into place, after
installation or cleaning procedures. .
• Make sure that the installation and electrical connections of the appliance
are carried out by an authorized service agent. The manufacturer cannot
be held liable for damage caused by repairs carried out by unauthorized
persons.
• Before proceeding with the installation, check the product for any defects. If you
identify one, do not proceed with the installation. Damaged products pose risks
to your safety.
4.1.1 Suitable installation location
• Place the product on firm, level ground. Do not place your device on a high-
pile carpet or other similar surface.
• When the washing machine and the dryer are stacked, their total weight - when
loaded - is 180 kg. Place the product on solid, level ground with sufficient load-
bearing capacity.
• Do not install the product on the power cable.
• Do not install the product in environments where the temperature is below 0 ºC.
• To reduce vibration and noise, it is advisable to leave space around the
machine.
• If you are going to install the machine on a surface with steps, never place it close
to the edges.
• Do not place the product on a platform.
• Do not place or use any heat sources (hobs, irons, ovens, etc.) on the
washing machine.
8 / EN
Washing machine / User manual
