Beko WRYS 51022 C, User Manual

Page: 41 / 48

41 / EN
Washing Machine / User’s Manual
5 Maintenance and cleaning
Service life of the product extends and frequently faced problems decrease if cleaned at regular intervals.
5.1 Cleaning the detergent drawer
Clean the detergent drawer at regular intervals (every 4-5 washing cycles)
as shown below in order to prevent accumulation of powder detergent in
time.
Lift the rear part of the siphon to remove it as illustrated.
C
If more than normal amount of water and softener mixture starts to gather in the softener compartment,
clean the siphon.
2 Wash the detergent drawer and the siphon with plenty of lukewarm water in a washbasin. Wear
protective gloves or use an appropriate brush to avoid touching of the residues in the drawer with
your skin when cleaning.
3 After cleaning, replace the siphon back to its seating and push its front section downwards to make
sure that the locking tab engages.
5.2 Cleaning the loading door and the drum
Residues of softener, detergent and dirt may accumulate in your machine in time and may cause
unpleasant odours and washing complaints. To avoid this, use the Drum Cleaning programme. If
your machine is not featured with Drum Cleaning programme, use Cottons-90 programme and
select Additional Water or Extra Rinse auxiliary functions as well. Run the programme without any
laundry in the machine. Before starting the programme, put max. 100 g of powder detergents into the
main wash detergent compartment(compartment nr. 2). If the detergent is in tablet form, put only
one tablet into compartment nr. 2. Dry the inside of the bellow with a clean piece of cloth after the
programme has come to an end.
C
Repeat Drum Cleaning process in every 2 months.
Use an detergents suitable for the washing machines.
After every washing check that no foreign substance is left in the drum.
If the holes on the bellow shown in the figure is blocked, open the holes
using a toothpick.
C
Foreign metal substances will cause rust stains in the drum. Clean the stains on the drum surface by using
cleaning agents for stainless steel. Never use steel wool or wire wool.
A
WARNING:
Never use sponge or scrub materials. These will damage the painted and plastic surfaces.
5.3 Cleaning the body and control panel
Wipe the body of the machine with soapy water or non-corrosive mild gel detergents as necessary,
and dry with a soft cloth.
Use only a soft and damp cloth to clean the control panel.
5.4 Cleaning the water intake filters
There is a filter at the end of each water intake valve at the rear of the machine and also at the end of
each water intake hose where they are connected to the tap. These filters prevent foreign substances
and dirt in the water to enter the washing machine. Filters should be cleaned as they do get dirty.