10 - EN
When the “Program selection” button is
brought to the appropriate position, rpm and
temperature data reappear.
Switching the machine to standby mode
The machine is switched to standby mode
by pressing “Start/Pause/Cancel” button
momentarily. The Standby symbol which
indicates the machine is in standby mode
lights up and the start symbol that shows the
program has started and is still continuing
fades out.
Selecting or canceling an auxiliary
function in pause mode
Auxiliary functions can be cancelled or
selected in accordance with the step the
program is at.
Adding/removing laundry in pause mode
The door can be opened if the water level is
suitable. The door locked symbol will light
up until the door is suitable for opening. This
symbol will fade out as soon as the door is
allowed to open. Laundry may be added /
taken out by opening the door.
Door lock
The Door Locked Symbol lights up when the
loading door is locked. This symbol will flash
until the door is allowed to open. Do not force
the door at this stage. This symbol will fade
out as soon as the door is allowed to open.
You may open the door after the symbol fades
out.
Child-proof lock
Protect the appliance from being tampered
by children by means of the child-proof lock.
In this case, no change can be made in the
running program.
C
Your machine can be turned on and off
with On/Off button while the child-proof
lock is activated. In this case, your machine
will resume its program with child-proof
lock activated.
The machine is switched to child-lock by
pressing the 2nd and 4th auxiliary functions
for 3 sec. “C:on” (Child-proof lock is activated)
label appears on the display.
The same symbol will also be displayed
whenever any button is pressed while the
machine is child-locked.
To deactivate the child-proof lock, press the
2nd and 4th auxiliary function buttons for 3
sec.
“C:OFF” (Child-proof lock is deactivated) label
appears on the screen.
Ending the program through canceling
“Start/Pause/Cancel” button (Figure 2-10) is
pressed for 3 seconds to cancel the program.
Start symbol (Figure 3-7j) will flash during
cancellation. After cancellation, the symbol
of the corresponding step at which the
cancellation was made will remain lit and “End”
will appear on the screen.
End of program
When the program is finished, the symbols
of the relevant steps will remain lit up and
the auxiliary function, spin and temperature
data selected at the start-up of the program
will remain selected. “End” will appear on the
display.
5 Maintenance and cleaning
Detergent Drawer
Remove any powder residue buildup in the
drawer. To do this;
1. Press the dotted point on the siphon in the
softener compartment and pull towards
you until the compartment is removed from
the machine.
C
If more than a normal amount of water
and softener mixture starts to gather in the
softener compartment, the siphon must be
cleaned.
2. Wash the dispenser drawer and the
siphon with plenty of lukewarm water in a
washbasin.
3. Replace the drawer into its housing after
cleaning. Check if the siphon is in its
original location.
Inlet water filters
There is a filter at the end of each water intake
valve at the back side of the machine and also
at the end of each water intake hose where
they are connected to the tap. These filters
prevent the foreign substances and dirt in the
water to enter into the machine. Filters should
be cleaned as they get dirty.
• Close the taps.
• Remove the nuts of the water intake hoses
to clean the surfaces of the filters on the
water intake valves with an appropriate
brush.
• If the filters are very dirty, you can pull them
out by means of pliers and clean them.
