Beko WMC1282W, User Manual

Page: 10 / 40

10 / EN
Washing Machine / User‘s Manual
3 Installation
Refer to the nearest Authorised Service Agent
for installation of the product. To make the
product ready for use, review the information
in the user manual and make sure that the
electricity, tap water supply and water drainage
systems are appropriate before calling the
Authorised Service Agent. If they are not, call
a qualified technician and plumber to have any
necessary arrangements carried out.
C
Preparation of the location and
electrical, tap water and waste
water installations at the place of
installation is under customer's
responsibility.
Make sure that the water inlet and
discharge hoses as well as the power
cable are not folded, pinched or
crushed while pushing the product
into its place after installation or
cleaning procedures.
B
WARNING:
Manufacturer shall not
be held liable for damages that may
arise from procedures carried out by
unauthorised persons.
A
WARNING:
Prior to installation,
visually check if the product has any
defects on it. If so, do not have it
installed. Damaged products cause
risks for your safety.
3.1 Appropriate installation location
• Place the machine on a rigid floor. Do not
place it on a long pile rug or similar surfaces.
• Total weight of the washing machine and the
dryer -with full load- when they are placed
on top of each other reaches to approx. 180
kilograms. Place the product on a solid and
flat floor that has sufficient load carrying
capacity!
• Do not place the product on the power cable.
• Do not install the product at places where
temperature may fall below 0ºC.
• Place the product at least 1 cm away from the
edges of other furniture.
3.2 Removing packaging
reinforcement
Tilt the machine backwards to remove
the packaging reinforcement. Remove the
packaging reinforcement by pulling the ribbon.
3.3 Removing the transportation
locks
A
WARNING:
Do not remove the
transportation locks before taking
out the packaging reinforcement.
WARNING:
Remove the
transportation safety bolts before
operating the washing machine!
Otherwise, the product will be
damaged.
1. Loosen all the bolts with a suitable spanner
until they rotate freely (C) .
2. Remove transportation safety bolts by
turning them gently.