32 / EN
Washing Machine / User‘s Manual
Maintenance and cleaning
A
WARNING:
Foreign substances left
in the pump filter may damage your
machine or may cause noise problem.
In order to clean the dirty filter and discharge
the water:
1. Unplug the machine to cut off the supply
power.
A
WARNING:
Temperature of the water
inside the machine may rise up to 90 ºC.
To avoid burning risk, filter must be
cleaned after the water in the machine
cools down.
2. Open the filter cap.
If the filter cap is composed of two pieces,
press the tab on the filter cap downwards
and pull the piece out towards yourself.
If the filter cap is one piece, pull the cap from
both sides at the top to open.
C
You can remove the filter cover by
slightly pushing downwards with a thin
plastic tipped tool, through the gap
above the filter cover. Do not use metal
tipped tools to remove the cover.
3. Some of our products have emergency
draining hose and some does not have.
Follow the steps below to discharge the
water.
Discharging the water when the product has an
emergency draining hose:
a. Pull the emergency draining hose out from
its seat
b. Place a large container at the end of the
hose. Drain the water into the container by
pulling out the plug at the end of the hose.
When the container is full, block the inlet
of the hose by replacing the plug. After
the container is emptied, repeat the above
procedure to drain the water in the machine
completely.
c. When draining of water is finished, close the
end by the plug again and fix the hose in its
place.
d. Turn the pump filter to take it out.
4. Clean any residues inside the filter as well
as fibres, if any, around the pump impeller
region.
5. Install the filter.
6. If the filter cap is composed of two pieces,
close the filter cap by pressing on the tab.
If it is one piece, seat the tabs in the lower
part into their places first, and then press the
upper part to close.
