22 / EN
Washer-Dryer
Installation
90 cm
90
40
90
40
90 cm
90 cm
min.40
• Connect the hose to a minimum height of 40 cm and a maximum height of 90 cm.
• If the hose is run along the floor (or at less than 40 cm above it) and raised later on,
water drain becomes difficult and laundry may come out extremely wet. Therefore,
observe the heights described in the figure.
• To prevent flowing of dirty water back into the machine and to allow for easy
discharge, do not immerse the hose end into the dirty water or do not drive it in the
drain more than 15 cm. If it is too long, cut it short.
• The end of the hose should not be bent, it should not be stepped on and the hose
must not be pinched between the drain and the machine.
• If the length of the hose is too short, add an original extension hose. Length of the
hose may not be longer than 3.2 m. To avoid water leak failures, the connection
between the extension hose and the drain hose of the product must be fitted well
with an appropriate clamp as not to come off and leak.
3.6 Adjusting the feet
A
CAUTION
• Adjust feet so that the product will be balanced in the
location it will be used.
• Balance the machine by adjusting the feet.
• Check for any play by pressing the product from upper
diagonal edges.
• Otherwise, the product may move from its place and
cause crushing, noise and vibration problems.
• Do not use any tools to loosen the lock nuts.
Otherwise, the lock nuts may get damaged.