15
EN
Press and hold 2
nd
and 4
th
Auxiliary Function
buttons for 3 seconds. “Con” appears on the
display.
Same phrase will appear on the display if
you press any button when Child Lock is
enabled.
To deactivate the Child Lock:
Press and hold 2
nd
and 4
th
Auxiliary Function
buttons for 3 seconds. “COFF” appears on the
display.
Do not forget to disable the child lock
at the end of the programme if it was
enabled before. Otherwise, machine will
not allow to select a new programme.
Canceling the programme
Press and hold Start / Pause / Cancel button
for 3 seconds. Start symbol flashes. Symbol
of the step at which the programme was
cancelled remains lit. “
END
” appears on the
display and the programme is cancelled.
If you want to open the loading door after
you have cancelled the programme but it
is not possible to open the loading door
since the water level in the machine is
above the loading door opening, then
turn the Programme Selection knob to
Pump+Spin programme and discharge
the water in the machine.
Machine is in Rinse Hold mode
Spin symbol flashes and Pause symbol
illuminates when the machine is in Rinse Hold
mode.
If you want to spin your laundry when the
machine is in this mode:
Adjust the spin speed and press Start / Pause
/ Cancel button. Pause symbol disappears and
Start symbol appears. Programme resumes,
discharges the water and spins the laundry.
If you only want to drain the water without
spinning:
Just press Start / Pause / Cancel button.
Pause symbol disappears. Start symbol
appears. Programme resumes and discharges
the water only.
End of programme
“End” appears on the display at the end of
the programme. Symbols of the programme
steps remain lit. Auxiliary function, spin speed
and temperature that were selected at the
beginning of the programme remain selected.
Your machine is equipped with
a “Standby Mode”
In case of not starting any programme or
waiting without making any other operation
when the machine is turned on by On/Off
button and while it is in selection step or if
no other operation is performed approximately
2 minutes after the programme you selected
has come to an end,your machine will
automatically switch to energy saving mode.
Display brightness will decrease. In case of
rotating the Programme Selection knob or
pressing any button, lights will restore to their
previous condition. This is not a fault.
