Beko QZ32, Installation & Operating Instructions Manual, Page: 20 / 28

EN
19
4 Before operating
Final Check
Before you start using the freezer
check that:
1. The feet have been adjusted and the
product is level.
2. The interior is dry and air can circulate
freely at the rear.
3. Clean the interior as recommended
under "CLEANING AND CARE."
4. Insert the plug into the wall socket
and switch on the electricity supply.
Avoid accidental disconnection by
taping over the switch.
5. You will hear a noise as the
compressor starts up. The liquid and
gases sealed within the refrigeration
system may also give rise to noise,
whether the compressor is running
or not which is quite normal.
6.
Front edges of the cabinet may feel
warm. This is normal. These areas
are designed to be warm to avoid
condensation.
7. Do not load the appliance
immediately it is switched on. Wait
until the correct storage temperature
has been reached. We recommend
that you check the temperature
with an accurate thermometer
(see; Temperature Control and
Adjustment).
Important Notes :
1. If there is a power failure do not open
the door. Frozen food should not be
affected if the failure lasts for less than
19 hours. If the failure is longer, then
the food should be checked and either
eaten immediately or cooked and then
re-frozen.
2.
If you find the freezer door difficult to
open just after you have closed it,
don't worry. This is due to the pressure
difference which will equalise and allow
the door to open normally after a few
minutes.
3. Always wrap food using a suitable
packaging material before storing
in your appliance to avoid contact
with the appliance surface and food
remains for hygiene reasons.
4. The appliance may go OFF when the
thermostat is adjusted below MIN.
position. When the green indicator light
is OFF, the appliance is turned OFF
also.
Once it is turned OFF (even
for defrosting), please adjust the
thermostat somewhere above MIN
to be sure that it is turned ON again.
When the appliance is turned ON, the
green indicator will light up.