15 / EN
Built-In Hob / User Manual
•
Connection must comply with national regula-
tions.
•
The mains supply data must correspond to the
data specified on the type label of the product.
Type label is at the rear housing of the product.
•
Power cable of your product must comply with
the values in “Technical specifications” table.
B
Before starting any work on the
electrical installation, disconnect
the product from the mains supply.
There is the risk of electric shock!
C
Power cable plug must be within
easy reach after installation (do not
route it above the hob).
Plug the power cable into the socket.
3.4 Gas connection
A
WARNING:
Product can be con-
nected to gas supply system only by
an authorised and qualified person
or technician with licence.
Risk of explosion or toxication due to
unprofessional repairs!
Manufacturer shall not be held re-
sponsible for damages arising from
procedures carried out by unauthor-
ised or unlicensed persons.
A
WARNING:
Before starting any
work on the gas installation, discon-
nect the gas supply.
There is the risk of explosion!
Gas adjustment conditions and values are stated
on labels (or ion type label).
C
The gas type of your product is stat-
ed on type label placed bottom of
hob.
3.4.1 Connecting the gas hose
For NG
•
Natural gas installation must be prepared before
installing the product.
•
There must be a pipe (Piping advised to be buyed
from a licensed installer), must comply with local
gas standard, at the outlet of the ins-tallation
for the natural gas connection of your product
and the tip of this pipe must be closed with a
blind plug. Service Representative will re-move
the blind plug during connection and con-nect
your product by means of a straight connec-tion
device (coupling).
•
Make sure that the natural gas valve is readily
accessible.
•
If you need to use your product later with a
different type of gas, you must consult the
Aut-horised Service Agent for the related con-
version procedure.
3.4.2 Connecting the gas hose
For LPG
•
Have your product connected in a way that it will
be close to the gas connection and not gas lea-
kage will exist.
•
Plastic hose to be used must not be longer than
125 cm.
•
Install the clamp to the hose. Soak one end of
the hose (15 mm inner diameter) into boiling
water for one minute to soften it.
•
Than, slip the softened end of the hose com-
ple-tely onto the sharp hose tip of your product.
Fi-nally, tighten the clamp completely with a
screwdriver.
A
WARNING:
Risk of explosion and
suffocation!
Do not keep LPG cylinders in home.
3
Installation
Summary of Contents for HISW 63222 SO
Page 1: ...Built In Hob User manual 01M 8869993200 3918 01 EN FR ES DE PT HISW 63222 SO ...
Page 135: ......
Page 136: ...www beko com ...