EN
8
3
Installation
Transportation Instructions
1.
The appliance should be
transported only in a vertical upright
position. The packing as supplied
must be intact during transportation.
2.
If during the course of
transport the appliance has to be
transported horizontally, it must
only be laid on its right hand side
when standing in the front of the
appliance. After bringing it to
upright position,it must not be
operated for at least 4 hours to
allow the system to settle.
3.
Failure to comply with the
above instructions could result in
damage occuring to the appliance.
The manufacturer will not be held
responsible if these instructions are
disregarded.
4.
The appliance must be protected
against rain, moisture and other
atmospheric influences.
5.
Empty any water in the drain tray
before moving see section “Defrosting”
and “Cleaning & Care” for further
information
IMPORTANT :
Make sure the plastic
evaporating pan at the back of the
product collects water properly.
“IMPORTANT:
Care must be taken
while cleaning / carrying the appliance
to avoid touching the bottom of the
condenser metal wires at the back of
theappliance as you might injure your
fingers and hands.
“IMPORTANT:
This appliance is not
designed for stacking with any other
appliance.When positioning your
appliance, take care not to damage
your flooring, pipes,wall coverings etc.
Do not move the appliance by pulling
by the door or handle.Do not attempt
to sit or stand on top of your appliance
as it is not designed for such use. You
could injure yourself or damage the
appliance.
“IMPORTANT:
Make sure that
mains cable is not caught under the
appliance during and after carrying
/ moving the appliance, to avoid
the mains cable becoming cut or
damaged.”Do not allow children to play
with the appliance or tamper with the
controls.
BEKO declines to accept any liability
should the instructions not be followed.
Installation Instructions
1.
If possible avoid placing the
appliance near cookers, radiators or in
direct sunlight as this will cause the
compressor to run for long periods.
If installed next to a source of heat
or refrigerator, maintain the following
minimum side clearances:
From Cookers 2” (50 mm)
From Radiators 12” (300 mm)
From Refrigerators or Larder Fridge
1” (25 mm)
2.
No gap is required at sides and
top. See item 3 below to ensure a
gap is obtained at the rear of the
appliance. If a gap is available on side
and top, retain it if possible as it would
