Beko DWD5412, Installation & Operation Manual

Page: 16 / 28

15
GB
hardness shown in the manual.
Put the rinse aid setting at the •
correct level.
Filling detergent dispenser
If the dishwasher is considerably full
and the dishes are relatively dirty, fill
the main container (A) up to 25cm³
level. If the dishwasher is not quite full
and the dishes are only slightly soiled,
fill the main container (A) only up to
15cm³ level.
If your dishes are kept unwashed for
a long time and the food particles are
stuck on the dishes also fill the small
container (B) up to 5cm³. Depending
on the degree of soiling and the
water hardness in your area it may be
necessary to add more detergent.
Powder and gel detergents are poured
into the dispenser.
If you are using tablet detergent read
the manufacturer’s recommendations
on the packaging in order to determine
where the tablets should be placed
inside the dishwasher (detergent
dispenser, cutlery basket, etc.)
Using two-in-one detergent and
rinse aid
These detergents will not give you •
the same drying performance that
you can obtain by using separate
detergent, salt and rinse aid. To
increase the drying performance:
Put your appliance’s rinse aid •
setting at “1” and apply rinse aid.
When the rinse aid is used up,
add more rinse aid to the rinse aid
dispenser.
If you use combined detergents •
with a rinse aid setting higher
than 1, hand contact may leave
rainbow-coloured water stains on
the washed items and inside the
machine.
These detergents do not contain •
softening salt so you need to use
the softening setting as described
in the manual, making sure that
there is salt in the water softener
with every wash and that you refill
the water softener with salt every
time it is empty.
Important warning
Should you encounter a problem that
has previously never occured after you
start using these detergents, contact
the detergent manufacturer directly.
You will find contact details on the
packet.
If you stop using this kind of
detergent:
Ensure that the salt and rinse aid •
dispensers are full.
Put the water hardness setting at •
the highest level and run a wash
cycle with the appliance empty.
After washing while empty, return •
the water hardness setting to the
correct level for your mains water