
19 EN
Adding/removing laundry in
standby mode
In order to add or remove laundry after
the programme starts:
1. Press the “Start/Pause/Cancel” button
to switch the dryer to “Pause” mode.
Drying process will stop.
2. Open the door at “Pause” position and
close it again after adding or taking out
laundry.
3. Press “Start/Pause/Cancel” button to
start the programme.
C
Any laundry added after the drying
process has started may cause
the dried clothes in the machine
intermingle with wet clothes and the
result will be wet laundry after the
drying process is over.
C
Laundry may be added or taken out
as much as desired during a drying
process, but this process will extend
the programme duration and increase
energy consumption since the drying
will be interrupted continuously.
Therefore, it is recommended to add
laundry before the drying programme
has started.
Child-proof lock
There is a child-proof lock to prevent
any programme interruption due to the
pressing of button while the programme
is running. The loading door and all
buttons except the “On/Off” button on
the control panel are deactivated when
the child-proof lock is active.
Press the “Start/Pause/Cancel” and
“Cancel audio warning” buttons
simultaneously for 3 seconds to activate
the child-press lock.
To start a new programme after the
programme is over or to interrupt the
programme, the child-proof lock should
be deactivated. Press the same buttons
for 3 sec. again to deactivate the child-
proof lock.
C
Child-proof lock is deactivated when
the machine is restarted by pressing
the On/Off button.
C
Press the relevant buttons for 3
seconds to activate the child-proof
lock. A long beep will be heard and
the child-proof lock will be activated. A
double beep will be heard if you press
any button or turn the programme
selection knob while the child-proof
lock is active. Press the buttons for 3
seconds to deactivate the child-proof
lock. Single beep will be heard and
child-proof lock will be deactivated.
A
A double beep will be heard if
you turn the programme selection
knob when the machine is running
and the child-proof lock is active. If
you deactivate the child-proof lock
without returning the programme
selection knob to its previous position,
the programme will be terminated
since the position of the programme
selection knob is changed. The drying
light turns on and the machine remains
on hold until a new programme is
selected and the “Start/Pause/Cancel”
button is pressed.
Finishing by canceling the
programme
To cancel any selected programme:
Press “Start/Pause/Cancel” button for
about 3 seconds. The “Filter cleaning”,
“Water tank” and “End/ Anti-creasing”
warning lights will turn on at the end of
this period for reminding purposes.
A
As the inside of the dryer will be
excessively hot when you cancel the
programme while the dryer is running,
activate the ventilation programme to
cool it down.