Beko DPU 7305 XEL, User Manual

Page: 41 / 64

41 / 64 EN
Dryer / User Manual
2
Installation
Refer to the nearest Authorized Service Agent for
installation of the product. To make the product ready for
use, make sure that the electricity and water drainage
system are appropriate before calling the Authorized
Service Agent. If they are not, call a qualified technician
and plumber to have any necessary arrangements
carried out.
C
Preparation of the product’s location
as well as the electrical and waste
water installations is under customer’s
responsibility.
B
Installation and electrical connections of
the product must be carried out by the
Authorized Service Agent. Manufacturer
shall not be held liable for damages that
may arise from procedures carried out by
unauthorized persons.
A
Prior to installation, visually check if the
product has any defects on it. If so, do
not have it installed. Damaged products
cause risks for your safety.
A
Let your dryer wait for 12 hours before
starting to use it.
Appropriate installation location
• Install the product on a stable and level surface.
• Dryer is heavy. Do not move it by yourself.
• Operate your product in a well ventilated, dust-free
environment.
• Do not block the air ducts in front of and under
the product with materials such as long pile rugs,
wooden blocks and bands.
• Do not install the product behind a door with a
lock, sliding door or a hinged door which can strike
the product.
• Once the product is installed, it should stay at
the same place where its connections have been
made. When installing the product, make sure
that the rear wall of it does not touch anywhere
(tap, socket, etc.). Also pay attention to select an
installation location which you will not be required
to change afterwards.
• Place the product at least 1.5 cm away from the
edges of other furniture.
B
Do not place the product on the power
cable.
Removing the transportation safety
assembly
A
Remove the transportation safety
assembly before using the product for the
first time.
1. Open the loading door.
2. There is a nylon bag inside the drum that contains
a piece of styrofoam. Hold it from its section
marked with XX XX.
3. Pull the nylon towards yourself and remove the
transportation safety assembly.
A
Make sure that no part of the
transportation safety assembly remains
inside the drum.