Dishwasher / User’s Manual
35 / 45 EN
Operating the product
3. Unplug the machine from the socket.
C
For energy saving, the product
is automatically turned off
following the completion of the
programme or if the programme
is not started.
C
Leave your dishes in the machine
for about 15 minutes to cool
down after they are washed.
Your dishes will dry in a shorter
time if you leave the door of your
machine ajar during this period.
This process will increase the
drying effectiveness of your
machine.
Water cut-off warning
If mains water is cut or water inlet tap is
turned off the machine cannot take water
in and E:02 icon will flash on the programme
indicator. As long as the problem continues,
washing programme is paused and the
water inlet is checked regularly by the
machine; when the water is restored E:02
icon will disappear after a while and the
washing programme resumes.
Overflowing warning
If the machine intakes too much water or
there is leakage at any of the components
then the machine will detect this and E:01
icon will flash on the Programme indicator.
As long as the overflowing continues safety
algorithm will be active and try to discharge
the water. If overflowing stops and safety is
assured, E:01 icon will disappear. If E:01 does
not disappear, there is a permanent fault. In
this case the authorised service should be
contacted.
No rinse aid dispensed in P:0 wash position.
1 dose of rinse aid is dispensed in P:1
position.
2 doses of rinse aid are dispensed in P:2
position.
3 doses of rinse aid are dispensed in P:3
position.
4 doses of rinse aid are dispensed in P:4
position.
C
There might be residues of
detergent or rinse aid left in the
machine and / or on the pieces
being washed depending on the
step the programme you have
cancelled was in.
Salt indicator ( )
Please check the salt indicator on the display
to see whether there is adequate amount
of softening salt in the dishwasher or not.
You need to refill the salt reservoir with salt
whenever salt warning indicator appears on
the display of your machine.
C
Adjusting the water hardness
level is explained in Water
Softening System section.
Rinse Aid indicator ( )
Please check the rinse aid indicator on the
display to see whether there is adequate
amount of rinse aid in the dishwasher or
not. You need to refill the rinse aid reservoir
with rinse aid whenever rinse aid warning
indicator appears on the display of your
machine.
End of programme
End of Programme indicator will light up
once the washing programme is over.
1. Press the On/Off button to turn off your
machine.
2. Close the tap.
Summary of Contents for DFN39533X
Page 47: ......
