8
GB
Warning
This appliance must be
earthed
If the fitted moulded plug is not
suitable for your socket, then the plug
should be cut off and an appropriate
plug fitted.
Destroy the old plug, which is cut
off as a plug with a bared cord could
cause a shock hazard if inserted into a
socket elsewhere in the house.
The moulded plug on this appliance
incorporates a 13A fuse. Should the
fuse need to be replaced an ASTA
approved BS1362 fuse of the same
rating must be used. Do not forget to
refit the fuse cover. In the event of
losing the fuse cover, the plug must
not be used until a replacement fuse
cover has been fitted. Colour of the
replacement fuse cover must be the
same colour as that visible on the
pin face of the plug. Fuse covers are
available from any good electrical
store.
Important
Fitting a different plug
As the colours of the wires in the
mains lead of this appliance may
not correspond with the coloured
markings identifying the terminals on
your plug, proceed as follows:
1.
Connect the green - yellow or
green (earth) wire to the terminal
in the plug marked ‘E’ or with the
symbol
or coloured green
and yellow or green.
2.
Connect the blue (neutral) wire to
the terminal in the plug marked
‘N’ or coloured black.
3.
Connect the brown (live) wire to
the terminal in the plug marked ‘L’
or coloured red.
With the alternative plugs a 13A fuse
must be fitted either in the plug or
adaptor or in the main fuse box. If in
doubt contact a qualified electrician.
Electrical requirements
Before you insert the plug into
the wall socket make sure that the
voltage and the frequency shown in
the rating label corresponds to your
electricity supply.
We recommend that this appliance be
connected to the mains supply via a
suitable switched and fused socket in
a readily accessible position.
If the supply cord or the mains lead
is damaged please do not replace
it yourself. The supply cord or the
mains lead must be replaced by a
Beko Authorised Service Agent or a
similarly qualified person.
