24
USA
or not. You need to refill the salt reservoir
with salt whenever salt indicator appears on
the display of your machine.
C
Adjusting the water hardness
level is explained in Water
Softening System section.
6.9 RINSE AID INDICATOR ( )
Please check the rinse aid indicator on the
display to see whether there is adequate
amount of rinse aid in the dishwasher or
not. You need to refill the rinse aid reservoir
with rinse aid whenever rinse aid indicator
appears on the display of your machine.
End of Program indicator will light up when
the washing program is over.
1. Open the door of the machine.
2. Press On/Off key to turn off your machine.
3. Close the tap.
4. Unplug the machine from the socket.
C
For energy saving, the machine
is automatically turned off
following the completion of the
program or if the program is not
started.
C
Leave your dishes in the
machine for about 15 minutes
to allow them cool down after
they are washed. Your dishes
will dry in a shorter time if you
leave the door of your machine
ajar during this period. This
process will increase the drying
effectiveness of your machine.
6.11 WATER CUT-OFF
WARNING
If mains water is cut or water inlet tap is
turned off the machine cannot take water
in and E:02 icon will flash on the program
indicator. As long as the problem continues,
washing program is paused and the water
inlet is checked regularly by the machine;
when the water is restored E:02 icon will
disappear after a while and the washing
program resumes.
6.12 OVERFLOWING WARNING
If the machine intakes too much water or
there is leakage at any of the components
then the machine will detect this and E:01 icon
will flash on the Program indicator. As long as
the overflowing continues safety algorithm
will be active and try to discharge the water. If
overflowing stops and safety is assured, E:01
icon will disappear. If E:01 does not disappear,
there is a permanent fault. In this case the
authorised service should be contacted.
Adjusting the amount of rinse aid
1. After switching on your machine, press
the Menu key for 1 second.
2. Using <- and +> keys, proceed to “P:”
on the display.
3. Set to the appropriate level with the
Selection key.
4. Press the Menu key to exit the settings
menu. Your setting will be saved
automatically.
No rinse aid dispensed in P:0 wash position.
1 dose of rinse aid is dispensed in P:1
position.
2 doses of rinse aid are dispensed in P:2
position.
3 doses of rinse aid are dispensed in P:3
position.
4 doses of rinse aid are dispensed in P:4
position.
6.10 END OF PROGRAM
C
When the program you have
selected comes to an end, an
audible warning signal will warn
you to turn off your machine.
This audible signal will warn you
with certain intervals before it
turns off.
Summary of Contents for DDT38530XWS
Page 46: ......
