Beko DDN25401X, Installation Manual

Page: 5 / 31

2
USA
• If the dishwasher is installed in a
location that experiences freezing
temperatures (e.g. in a vacation home,
cabin, etc.), you must drain all the
water from the dishwasher’s interior.
Water system ruptures that occur as
a result of freezing are not covered by
warranty.
• Dishwasher must be secured to
adjacent cabinetry using the brackets
provided. Failure to do this may cause
damage to property or bodily injury.
• Connect to a properly rated, protected
and sized power supply circuit to avoid
electrical overload. The dishwasher
is designed for an electrical supply
of 120 V (volts), 60 Hz (hertz), AC,
connected to a dishwasher-dedicated,
properly grounded electrical circuit
with a fuse or breakers rated for 15
amperes. Electrical supply conductors
shall be a minimum of # 16 AWG
copper wire rated at 75 °C (167 °F) or
higher. These requirements must be
met to prevent injury and machine
damage. Consult a qualified electrician
if in doubt.
• Do not use any extension cord or
portable outlet device to connect the
dishwasher to a power supply.
• Ensure that any plastic wrappings,
bags, small pieces etc. are disposed
of safely and kept out of the reach of
children. Danger of suffocation!
• Remove the door to the washing
compartment when removing an old
dishwasher from service or discarding
it. Ensure that the appliance presents
no danger to children while being
stored for disposal.
• Old appliances may contain materials
that can be recycled. Please contact
your local recycling authority about
the possibility of recycling these
materials.
NOTICE :
• The dishwasher drain hose must be
installed with a drain loop at least
28” (710mm) off the cabinet floor;
otherwise the dishwasher may not
drain properly.
• This dishwasher is intended for
residential use only, and should not be
used in commercial establishments.
• New installation - If the dishwasher is
a new installation, most of the work
must be done before the dishwasher is
moved into place.
• Replacement - If the dishwasher is
replacing another dishwasher, check
the existing dishwasher connections
for compatibility with the new
dishwasher, and replace parts as
necessary.
1.1 INSPECT THE DISHWASHER
After unpacking the dishwasher and prior
to installation, thoroughly inspect the
dishwasher for possible freight or cosmetic
damage. Report any damage immediately.
NOTICE :
• Cosmetic defects must be reported
within 10 days of installation.
• Do not discard any bags or items that
come with the original package until
after the entire installation has been
completed.