Beko DDN25401X, Installation Manual

Page: 15 / 31

12
USA
WARNING
Installation should be performed by a qualified installer. Work by unqualified
persons could be dangerous and may void the warranty.
If the dishwasher is installed in a location that experiences freezing
temperatures (e.g. in a vacation home, cabin etc.), you must drain all the
water from the dishwasher’s interior. Water system ruptures that occur as a
result of freezing are not covered by warranty.
6.6 DRAIN PREPARATION
The dishwasher drain hose may be connected to the drain plumbing in one of three ways
(Figure A , B , C ).
NOTICE :
• Either one of the above methods must be used or the
dishwasher will not operate properly.
• A hose that attaches to a sink spray can burst if it is installed
on the same water line as the dishwasher. If your sink has
one, it is recommended that the hose be disconnected and
the hole plugged.
• The total length of the drain hose is 763/4” (1950mm). If a
hose extension is required, a drainage hose of equal quality
must be used.
• The maximum length must not exceed 157 ½” (4000mm).
Otherwise, the cleaning process is negatively influenced.
6.6.1 UNDER THE SINK DRAIN
Install a Y-branch tail pipe. (Figure A )
NOTICE :
You must add a loop at least 28” (710mm) above the floor of
the cabinet and above the drain connection in the drain hose to
prevent waste water from not draining properly, and causing
either poor washing results or a bad odor.
6.6.2 INSTALLING AN AIR GAP
If the local ordinance requires an air gap (Figure B ).
NOTICE :
Check with local ordinance for type of air gap required.
6.6.3 DISPOSAL
Remove the drain connection plug before attaching the drain
hose from the dishwasher.
Every disposal has a hook up for a dishwasher; consult your
disposer manual for correct connection. (Figure C )