Beko DCY 8402 XW3, User Manual

Page: 26 / 56

26 / 56 EN
Dryer / User Manual
7
Troubleshooting
Drying process takes too much time.
Pores of the lint filter are clogged. >>> Wash the lint filter with warm water.
Condenser may be clogged.
>>> Clean the Condenser
.
Ventilation grids on the front side of the machine are blocked. >>> Remove the objects (if any) that block
ventilation in front of the ventilation grids.
Ventilation may not be sufficient since the room where the machine is installed is very small. >>> Open the door
and window of the room to avoid the room temperature increase too much.
Lime deposit has built up on the dampness sensor. >>> Clean the dampness sensor.
Excessive laundry might have been loaded in. >>> Do not load the dryer in excess.
Laundry might not be spun sufficiently. >>> Spin your laundry at a higher speed in your washing machine.
Laundry comes out wet at the end of drying.
C
After drying, the hot clothes feel damper than their actual dampness level.
A programme suitable for the laundry type might have not been used.>>> Check the garment tag and select a
programme suitable for the fabric type or use the timer programmes additionally.
Pores of the lint filter are clogged. >>> Wash the lint filter with warm water.
Condenser may be clogged. >>> Clean the Condenser .
Excessive laundry might have been loaded in. >>> Do not load the dryer in excess.
Laundry might not be spun sufficiently. >>> Spin your laundry at a higher speed in your washing machine.
Dryer does not switch on or the programme does not start. Dryer does not start when it is set.
It might have not been plugged in. >>> Make sure that the machine is plugged in.
The loading door is ajar. >>> Make sure that the loading door is closed securely.
Programme is not selected or the Start / Pause button is not pressed. >>> Make sure that the programme is
selected and the machine is not in Pause mode.
"Childproof lock" might have been activated. >>> Deactivate the Childproof Lock.
Programme is interrupted without any cause.
The loading door might not be closed securely. >>> Make sure that the loading door is closed securely.
A power failure might have occurred. >>> Press Start / Pause button to start the program.
Water tank may be full. >>> Drain the water tank.
Laundry has shrunk, become felted or deteriorated.
A programme suitable for the laundry type might have not been used. >>> Check the garment tag and select a
programme suitable for the fabric type.
Drum lighting does not turn on. (On models with lamp)
Dryer might not be switched on with the On / Off / Cancel button. >>> Make sure that the dryer is switched on.
Bulb may have blown. >>> Call Authorized Service Agent to have the lamp replaced.
Filter Cleaning warning symbol light is on.
Lint filter is not cleaned. >>> Clean the lint filter.
Lint Filter Cleaning symbol is flashing.
Filter housing is clogged with lints. >>> Clean the lint filter housing.
A deposit has built up on the lint filter pores that may cause clogging. >>> Wash the lint filter with warm water.
Condenser may be clogged.
>>> Clean the Condenser
.