
44 EN
Cancel” button to start the programme after
you have emptied the water tank. The warning
light turns off and the programme resumes
operating.
Starting the programme
1. Press “Start/Pause/Cancel” button to start
the programme.
2. Light of the “Start/Pause/Cancel” button
will turn on to indicate that the programme
has started.
Progress of program
Progress of a running program is shown
through the program follow-up indicator.
At the beginning of every program step, the
relevant indicator LED will light up and light of
the completed step will turn off.
“Drying”:
- Drying level will be illuminated during the
whole drying process until the drying
degree reaches “iron dry”.
“Iron Dry”:
- Starts to illuminate when the drying degree
reaches “iron dry” step and remains
illuminated until the next step.
“Ready to wear”:
Starts to illuminate when the drying degree
reaches “Ready to wear” step and remains
illuminated until the next step.
Illuminates when the program comes to an
end and anti-creasing function is activated.
“Final / Anti-creasing”:
- Illuminates when the program comes to an
end and anti-creasing function is activated.
C
If more than one LED light up or
flash concurrently, it means there is
malfunctioning or a failure (please see,
Solution suggestions for problems).
Changing the programme after
it has started
You can use this feature to dry your clothes
under higher or lower temperatures after your
dryer has started.
For example;
1. Press and hold the “Start/Pause/Cancel”
button for about 3 seconds to “Cancel”
the programme in order to select “Extra
Dry” programme instead of “Iron Dry”
programme.
2. Select the “Extra Dry” programme by
rotating the programme selection button.
3. Press “Start/Pause/Cancel” button to start
the programme.
C
Press Start button for 3 seconds to cancel
the programme or turn the programme
selection knob in any direction to end the
programme while the machine is running.
Water tank and filter cleaning LEDs turn
on to warn the user when the programme
is cancelled by pressing the Start button
for 3 seconds. However, the warning
LEDs do not turn on when the programme
is cancelled by turning the programme
selection knob. Only the drying LED turns
on and the machine remains in hold until a
new programme is selected and the Start
button is pressed. Child-proof lock of the
machine should not be active in order to
perform these two operations. If the child-
proof lock is active, deactivate it before
performing these operations.
Adding/removing laundry in standby
mode
In order to add or remove laundry after the
programme starts:
1. Press the “Start/Pause/Cancel” button to
switch the dryer to “Pause” mode. Drying
process will stop.
2. Open the door at “Pause” position and
close it again after adding or taking out
laundry.
3. Press “Start/Pause/Cancel” button to start
the programme.
C
Any laundry added after the drying process
has started may cause the dried clothes in
the machine intermingle with wet clothes
and the result will be wet laundry after the
drying process is over.
C
Laundry may be added or taken out
as much as desired during a drying
process, but this process will extend the
programme duration and increase energy
consumption since the drying will be
interrupted continuously. Therefore, it is
recommended to add laundry before the
drying programme has started.
Child-proof lock
There is a child-proof lock to prevent any
programme interruption due to the pressing
of button while the programme is running.
The loading door and all buttons except
the “On/Off” button on the control panel
are deactivated when the child-proof lock is
active.
Press the “Start/Pause/
Cancel” and “Cancel
audio warning” buttons
simultaneously for 3
seconds to activate the
child-press lock.
To start a new programme after the
programme is over or to interrupt the