Beko BKS 1350 T, User Manual

Page: 11 / 72

11 / 57 EN
Vacuum cleaner / User manual
5 Troubleshooting
Suction power is very low
•
Suction power control is very wide. >>> Close
the slide.
•
Blocked floor brush >>> Remove the bloc-
kage in floor brush.
•
Dust chamber is full. >>> Empty the dust
chamber
•
Filters are dirty. >>> Clean the filters.
Unit stopped abruptly while operating
•
Thermic might be blown. >>> Clean the dust
container and filters. Continue on cleaning
after 40 minutes
.
5.1 Thermic Motor Protector
Your vacuum cleaner is equipped with a thermic
protector that protects the appliance when the
motor is excessively heated due to low intake
power and blocked filter. If the exhaust outlet of
your vacuum cleaner heats up and the cleaner
stops suddenly by itself, follow the procedure
below:
1. Turn off and unplug the vacuum cleaner.
2. Look for the cause of the overheating (blocked
hose, blocked filter, etc.).
3. Wash the filters, especially the HEPA filter by
removing the fine dust carefully, if required. Let
the filters dry completely before replacing them.
4. Wait for about 40 minutes to allow cooling
of the motor and deactivation of the safety
mechanism.
5. After 40 minutes, plug in the vacuum cleaner
and turn it on.
6. If the vacuum cleaner does not operate,
unplug it again and check whether more time
is required to allow deactivation of the safety
mechanism by waiting for 20 minutes more.
5.2 Lower body plug
1. If your product sucks large pieces of paper,
napkin or socks, this will cause clogging in the
air channels and your product's suction power
will suddenly drop.
2. In such a case, open the lower body plug by
means of turning, remove the objects inside
and place the plug back it to continue with the
sweeping.