29 / EN
Washing Machine / User’s Manual
•
Use a flat screwdriver to remove the tabs holding the upper cover of the detergent drawer (there are
6 tabs in total: two on the right side of the drawer, two on the left and two at the back) and wash the
inside of the drawer.
•
After washing it, place the cover back to its location. Make sure that all tabs are fitted. If the tabs do not
seat properly, liquids may leak or the detergent drawer may get stuck or difficultly move on the drawer
slide. For this reason, please ensure that the tabs are fitted in place.
•
Fit the discharge bar to its slot at the back of the drawer.
•
Paying attention to its slot and slides, fit the drawer back in place and push it to close. After adding
detergent and softener, it will be ready to be used in programmes with dosing function.
4.4.2 Cleaning the loading door and the drum
For products with drum cleaning programme, please see Operating the product - Programmes.
Select
C
Repeat Drum Cleaning process in every 2 months.
Use an anti-limescale suitable for the washing machines.
After every washing make sure that no foreign substance is left in the
product.
If the holes on the bellow shown in the figure is blocked, open the holes
using a toothpick.
Foreign metal substances will cause rust stains in the drum. Clean the
stains on the drum surface by using cleaning agents for stainless steel.
Never use steel wool or wire wool. These will damage the painted,
chromated and plastic surfaces.
4.4.3 Cleaning the body and control panel
Wipe the body of the product with soapy water or non-corrosive mild gel detergents as necessary, and dry
with a soft cloth.
Use only a soft and damp cloth to clean the control panel.
4.4.4 Cleaning the water intake filters
There is a filter at the end of each water intake valve at the rear of the product and also at the end of each
water intake hose where they are connected to the tap. These filters prevent foreign substances and dirt in
the water to enter the product. Filters should be cleaned if they are dirty.
