6 /37 EN
Refrigerator / User Manual
3
Installation
Refer to the nearest Authorized Service Agent for
installation of the product. To make the product
ready for use, make sure that the electricity
installation is appropriate before calling the
Authorized Service Agent. If not, call a qualified
electrician to have any necessary arrangements
carried out.
C
Preparation of the location and electrical
installation at the place of installation is
under customer's responsibility.
B
Product must not be plugged in during
installation. Otherwise, there is the risk of
death or serious injury!
B
WARNING:
Installation and electrical
connections of the product must be carried
out by the Authorised Service Agent.
Manufacturer shall not be held liable for
damages that may arise from procedures
carried out by unauthorised persons.
A
WARNING:
Prior to installation, visually
check if the product has any defects on
it. If so, do not have it installed. Damaged
products cause risks for your safety.
C
Make sure that the power cable is not
pinched or crushed while pushing the
product into its place after installation or
cleaning procedures.
3.1 Appropriate installation location
A
WARNING:
If the door of the room
where the product will be placed is too
small for the product to pass, then the
product's doors must be removed and the
product must be turned sideways to pass
it through.
t$IPPTFBQMBDFBUXIFSFZPVXPVMEVTFUIF
product comfortably.
t*OTUBMMUIFQSPEVDUBUMFBTUDN
” away from
heat sources such as hobs, ovens, heater cores
and stoves and at least 5 cm/
2
” away from
electrical ovens. Product must not be subjected
to direct sun light and kept in humid places after
installation.
t:PVSQSPEVDUSFRVJSFTBEFRVBUFBJSDJSDVMBUJPOUP
function efficiently. If the product will be placed
in an alcove, remember to leave at least
2
” from
ceiling, 1/2” from sides and 1 3/4” in the back.
t%POPUQMBDFUIFQSPEVDUPOUIFNBUFSJBMTTVDI
as rugs or carpets.
t1MBDFUIFQSPEVDUPOBOFWFOGMPPSTVSGBDFUP
prevent wobbling.
t%POPUJOTUBMMUIFQSPEVDUJOQMBDFTXIFSFUIF
temperature falls below 10
º
C /50°F.
C
If two coolers are to be installed side by
side, there should be at least 4 cm 1
1/2
”
distance between them.
3.2 Alcove installation parts
Make sure that the sufficient room is provided
around the appliance to ensure free air circulation.
For efficient functioning in the alcove, below parts
should be added to product.
circulation part
unscrew before the installation
Install the vertical metal bracket and
screw.
Summary of Contents for BFFD3624SS
Page 14: ...13 37 EN Refrigerator User Manual Installation Minimum clearances 21 9 2 557 mm 12 25 311 2mm ...
Page 16: ...15 37 EN Refrigerator User Manual Preparation Product Dimensions ...
Page 18: ...17 37 EN Refrigerator User Manual Preparation J ...