Beko BFFD3624SS, User Manual

Page: 29 / 112

28 /37 EN
Refrigerator / User Manual
Operating the product
5.20 Ion
(in some models)
Air is ionized by means of the ionizer system in
the fridge compartment air duct. Thanks to this
system, air-borne bacteria and odorising molecules
removed from the air.
5.21 Odor filter
(in some models)
Odor filter in the air duct of the fridge compartment
prevents build-up of unpleasant odors in the
refrigerator.
5.22 Using internal water dispenser
(in some models)
After connecting the refrigerator to a water source
or replacing the water filter, flush the water
system. Use a sturdy container to depress and
hold the water dispenser lever for 5 seconds,
then release it for 5 seconds. Repeat until water
begins to flow. Once water begins to flow, continue
depressing and releasing the dispenser paddle
(5 seconds on, 5 seconds off) until a total of 5-6
gallons.
(about 20 liter)
has been dispensed. This
will flush air from the filter and water dispensing
system, and prepare the water filter for use.
Additional flushing may be required in some
households. As air is cleared from the system,
water may spurt out of the dispenser.
Allow 24 hours for the refrigerator to cool down
and chill water. Dispense enough water every week
to maintain a fresh supply.
C
After 5 minutes of continuous
dispensing, the dispenser will stop
dispensing water to avoid flooding.
To continue dispensing, press the
dispenser paddle again.
5.23 Dispensing water
Hold a container under the dispenser spout while
pressing the dispenser pad.
Release the dispenser pad to stop dispensing.
C
It is normal for the first few glasses of
water taken from the dispenser to be
warm.
C
If the water dispenser is not used for a long
period of time, dispose of first few glasses
of water to obtain fresh water.
During initial use, you will have to wait
approximately 12 hours for the water to cool down.
Take out the glass a little while after you pull the
trigger.
5.24For using water dispenser
A
Before using your fridge first time and
after replacing your water filter, water
dispenser may drip drops of water. To
prevent water dripping or leaking from
dispenser, please bleed the air from
the system by dispensing 5-6 gallons
(about 20 liter) of water through the
water dispenser before the first use
and every time after you change
the water filter. This will remove any
air trapped in the system and stop
the water dispenser from leaking.
Checking coupler position and the
straightness of water line at the back
of the unit will be required if there’s an
obstruction in water flow.
C
If your water dispenser is leaking just a few
drops of water after you have dispensed some
water, this is normal.