Beko B7S-B7SLED, Service Handbook

Page: 12 / 100

B7S B7SLED WASHING MACHINE SERVICE HAND BOOK
12
5.4. Connection to the Supply Water
Required water pressure is between 1-10 bar (0.1-1 MPa) for the proper operation of the
machine. For the healthy operation of the machine, 10
– 80 liters of water per minute
should be supplied from a fully opened tap. If the water pressure is higher, attach a
pressure decrease valve.
If you will use the double water inlet product as a single water inlet (cold) , before
operating the product, make sure you insert the plug supplied with the product to the hot
water inlet. (It applies to the products with which blind plug group is supplied.)
WARNING: Single water inlet models should not be be connected to the hot water tap.
Laundry may be damaged or product may not operate according to the protection status.
WARNING:
Do not use the old or used water inlet hoses for the new product. It may
leave stains on your laundry.
Figure 5.5
WARNING: Make sure that the hot and cold water taps are connected correctly when the
product is being installed. Your laundry may come out hot at the end of the washing cycle
and wear out.
Figure 5.6
3. When hose connection is completed, check whether there is leak problems at the
connection points by opening the taps fully. In case of any leakage, close the tap and
remove the nut. Check the seal and tighten the nut again carefully. In order to prevent
the water leaks and resultant damages, keep the taps closed when you do not use the
product.
1. Connect the special hoses
supplied with the product to the
water inlets on the product. Hose
with red inscriptions (left) (Max.
90 ºC) is for hot water inlet, hose
with blue inscriptions (right) (Max.
25 ºC) is for cold water inlet.
2. Tighten the nuts of the
hose by hand. Never use
a tool when tightening the
nuts.