7 / 41EN
Refrigerator / User Manual
3
Installation
Always have the repair procedures
carried out by the Authorised Service
Agent. Manufacturer shall not be held
liable for damages that may arise from
procedures carried out by unauthorised
persons.
To make the product ready for use, make
sure that the electricity installation
is appropriate before calling the
Authorised Service Agent. If not, call
a qualified electrician to have any
necessary arrangements carried out.
C
Preparation of the location and
electrical installation at the
place of installation is under
customer's responsibility.
B
Product must not be plugged in
during installation. Otherwise,
there is the risk of death or
serious injury!
B
WARNING:
Manufacturer shall
not be held liable for damages
that may arise from procedures
carried out by unauthorised
persons.
A
WARNING:
Prior to
installation, visually check if
the product has any defects on
it. If so, do not have it installed.
Damaged products cause risks
for your safety.
C
Make sure that the power
cable is not pinched or crushed
while pushing the product into
its place after installation or
cleaning procedures.
3.1. Appropriate
installation location
A
WARNING:
If the door of the
room where the product will be
placed is too small for the product
to pass, then the product's doors
can be removed and the product
turned aside to pass it through.
• Choose a place at where you would
use the product comfortably.
• Install the product at least 30 cm away
from heat sources such as hobs, ovens,
heater cores and stoves. Product must
not be subjected to direct sun light and
kept in humid places after installation.
• Appropriate air ventilation must be
provided around your product in order
to achieve an efficient operation. If the
product is to be placed in a recess in
the wall, pay attention to leave at least
5 cm distance with the ceiling and side
walls.
• Do not place the product on the
materials such as rugs or carpets.
• Place the product on an even floor
surface to prevent jolts.
• Do not install the product in places
where the temperature falls below
-5°C.
C
If two coolers are to be installed
side by side, there should be at
least 4 cm distance between
them.
