The Adjustment Of Cuttıng Pressure
Accordıng to the grade of materıal, ıt prowıdes to regulate cuttıng pressure. The cuttıng
pressure should be redu ced when the blade ıs beıng dull. After that the blade must be
changed.
Area i :
this shows that the tension of the blade is less than it must be. Adjust the blade
tension.
Area ii :
this shows that the tension of the blade is normal
Area iii :
this shows that the tension of the blade is more than it must be. This may break theblade. Reduce the tension.
Hydraulıc vıce
: 30 bar
maın pressure
:30bar
Manuel Cuttıng Operatıon
1)
Swıtch on the maın swıtch.
2)
Select the manual-automatıc selector to posıtıon 2.
3)
Adjust s3 lımıt swıtch accordıng to the materıal’s dıameter or heıght.
4)
Press b3 pushbutton to go up the bow. ( s2 lımıt swıtch must be ın cırcuıt otherwıse the machıne does not work. )
5)
Adjust the lenght of the materıal to requıred lenght. (by usıng s4 swıtch.)
6)
Press start pushbutton. ( ın manual posıtıon, start pushbutton must be kept presed untıl the bow left s2 lımıt swıtch.)
7)
Regulate the cuttıng pressure by the throttınlıng valve.
8)
Because of counter, the machıne could be locked. In thıs sıtuatıon the machıne does not work. Upper lıne of counter must be preset
after that the reset button must be pressed.
9)
For the next cuttıng, follow the some way.
Automatic Cutting Operation
1.
Switch on the main switch.
2.
Sealet B6 selector to position 2.
3.
Adjust S2 limit switch according to the materials diameter or height.
4.
Press B3 puhbutton to the bow up.
5.
Select B6 selector to position 1.
6.
Slide the lenght-stop on the spindle until reaching required lenght and the tighten.
7.
Preset the number of cuts reqoired and press the reset button on the counter.
8.
Press start button the cutting operation.
9.
Regulate the cutting pressure by throtting valve.
After starting the cutting operation, you do not need any operation else, but according to the grade of meterial you switch on the
coolantpump or not.
P.s.
If the machine stopped without reaching preset number, the blade could be broken or the material lenght could be shortened.