BEKA BA564G, Manual, Page: 9 / 38

4.3 EMC
The BA564G complies with the requirements of the
European EMC Directive 2014/30/EU. For specified
immunity all wiring should be in screened twisted
pairs, with the screens earthed at a common point.
4.4 Units of measurement and tag marking
on scale card.
The Counter's units of measurement and tag
information are shown on a scale card which slides
into the instrument.
New Counters are supplied with a printed scale card
showing the requested units of measurement and tag
information. If this information is not supplied when
the instrument is ordered, a blank scale card will be
fitted which can easily be marked on-site with a dry
transfer or a permanent marker. Custom printed
scale cards are available from BEKA associates as an
accessory.
To remove the scale card from a Counter carefully pull
the transparent tab at the rear of the instrument
assembly away from the assembly as shown in
Fig 5a.
Fig 5a Removing scale card
To replace the scale card carefully insert it into the
slot on the right hand side of the input terminals as
shown in Fig 5b. Force should be applied evenly to
both sides of the scale card to prevent it twisting.
The card should be inserted until about 2mm of the
transparent tab remains protruding.
Fig 5b Inserting scale card into the
instrument assembly.
9