12
For Thermocouple Input – see Fig 8
Transmitter Summary
display of function
‘t.tYPE’ Thermocouple type
Selects
1 of 8 common types of
thermocouple.
See section 7.2.2
‘dEG’
Units of digital display
Selects
1 of 4 units of temperature.
See section 7.2.3
‘rESn’
Display resolution
Selects low or high display resolution.
See section 7.2.4
‘CJC’
Cold junction compensation
Turns thermocouple cold junction
compensation on or off.
See section 7.2.5
‘FAuLt’ Sensor fault analogue indication
Selects 1 of 3 under/over range output
currents to indicate that a sensor fault has
been detected. Sensor fault analogue
indication may be disabled.
See section 7.2.6
‘CAL’
Configuration of 4/20mA output
Defines transmitter input at which
transmitter output is 4 & 20mA.
See section 7.2.7
‘bAr’
Configuration of bargraph display
Defines digital display at which bargraph
is zero and full scale.
See section 7.2.8
‘CodE’
Access code for configuration menu
Enters four digit configuration menu
access code. Default code 0000 disables
this function.
See section 7.2.9
For Resistance Thermometer (RTD) Input see Fig 9
Transmitter Summary
display of function
‘r.tYPE’ Resistance thermometer type
Selects Pt100 or Pt1000 sensor
See section 7.2.10
‘dEG’
Units of digital display
Selects
1 of 4 units of temperature.
See section 7.2.3
‘rESn’
Display resolution
Selects low or high display resolution.
See section 7.2.4
Transmitter Summary
display of function
‘FAuLt’ Sensor fault analogue indication
Selects 1 of 3 under/over range output
currents to indicate that a sensor fault has
been detected. Sensor fault analogue
indication may be disabled.
See section 7.2.6
‘CAL’
Configuration of 4/20mA output
Defines transmitter input at which
transmitter output is 4 & 20mA.
See section 7.2.7
‘bAr’
Configuration of bargraph display
Defines digital display at which bargraph
is zero and full scale.
See section 7.2.8
‘CodE’
Access code for configuration menu
Enters four digit configuration menu
access code. Default code 0000 disables
this function.
See section 7.2.9
For Voltage and Resistance Inputs – see Fig 10
Transmitter Summary
display of function
‘dP’
Decimal point position
Defines position of displayed decimal
point.
See section 7.2.11
‘in-Lo’
Lower input and display
Defines lower voltage or resistance input
‘inVAL’ and corresponding digital display
‘diSP’.
See section 7.2.12
‘in-Hi’
Higher input and display
Defines higher voltage or resistance input
‘inVAL’ and corresponding digital display
‘diSP’.
See section 7.2.13
‘CAL’
Configuration of 4/20mA output
Defines the transmitter input at which
transmitter output is 4 & 20mA.
See section 7.2.7
‘bAr’
Configuration of bargraph display
Defines digital display at which bargraph
is zero and full scale.
See section 7.2.8
‘CodE’
Access code for configuration menu
Enters four digit configuration menu
access code. Default code 0000 disables
this function. See section 7.2.9
