BEKA BA367E-SS, Manual

Page: 20 / 58

Display Summary of function
di5P-1
Upper display
Defines whether
rAtE
or
totAL
are
shown on the upper display. The
other variable will be shown on the
lower display, providing the lower
display is
on
in function
dI5P-2
.
See section 6.9
di5P-2
Lower display
Turns the lower display, which
normally shows rate,
on
or
oFF
.
See section 6.10
dP
Position of decimal points
Defines the position of the decimal
point in both the total and rate
displays.
See section 6.11
5CALE . t
Total Scale Factor
5CALE . T
is a dividing factor that
converts the number of input pulses
into the required total display in
engineering units.
5CALE . t
may be
adjusted between 0.0001 & 99999.
e.g. if one input pulse represents 1
centimetre of dispensed cable and
the total display is required in
metres,
5CALE . t
should be set to
100.0 which is the number of
centimetres in a metre.
The total display is independent of
the rate display.
See section 6.12
5CALE . r
Rate scale factor
5CALE . r
is a dividing factor that
converts the input pulse rate into the
required rate display in engineering
units.
5CALE . r
may be adjusted
between 0.0001 and 99999. e.g. if
one pulse represents 2 pump
strokes and the rate display is
required in pump strokes,
5CALE . r
should be set to 2.0.
The rate display is independent of
the total display.
See section 6.13
Display Summary of function
t-bA5E
Timebase
Selectable multiplier allowing rate to
be displayed in units per second, per
minute or per hour.
Select:
tb-01
for rate / second
tb-60
for rate / minute
tb-3600
for rate / hour
See section 6.14
FiLtEr
Display filter
Is an adjustable digital filter to
reduce the noise on the rate display.
The filter has two parameters each
represented by a digit adjustable
between 0 and 9. The first digit
defines the amount of filtering
applied to the display, the second
digit the deviation from the displayed
rate at which the filter will be
overridden and the rate display will
move rapidly to the new value.
See section 6.15
uP or dn
Direction of count
Determines whether input pulses
increment or decrement the total
display.
See section 6.16
CLr VAL
Reset value
Defines a preset number to which
the total display will be set when the
BA367E-SS Counter is locally or
remotely reset. Enables the
instrument to count down from a
preset number.
See section 6.17
20