Appendix
Operating manual NORA Alu
V2.13 E
Page 42 of 52
13.6.2 Replacement of the front castors
Image 1:
Required tools:
1 Allen wrench
10 mm
Image 2:
Additional
parts/tools:
1 front castor
(Order number
K9200350)
1 x thread lock fluid
(medium tight)
Image 3:
Lay the NORA Alu
on one side. Make
sure that the NORA
Alu is not damaged.
Loosen and remove
the screw of the
castor.
Prior to screwing a
new castor, you
must apply thread
lock fluid (
medium
tight at least 21
Nm
) to the thread of
the screw.
Caution: the thread lock fluid must dry at least 3 hours before the device can be
loaded.
Should you use thread lock fluid from another manufacturer, the drying times
specified by this manufacturer must be observed!
Re-assemble in reversed order!
