Page 5
Description of the screens
Probe sgm595
sn 24ad12
date 41 18
DY 2190
cy 5
al 15
dr 12
range 20
ADC - 127 - 145
2
1
lel 20%
100 ppm
fault
gas methane
LPG ecc
3
OFS
64 70 72 80
4
5
Tar 175
180 200
PAGE 1
to scroll the page press “ENTER”
Displays: “Probe” The type of probe or device
Displays: “SN”
The serial number
Displays: “DATE”
The week and year of manufacture
Displays: “Dy”
the remaining days at the end of the operating cycle.
Displays: “Cy”
How many times the probe has been turned on.
Displays: “AL”
How many times is gone into alarm.
Displays: “DR”
How many corrections have been done
Displays: “RANGE” The operating range if at 20 or at 100% of LEL
Displays: “ADC” A scrolling to the normalized value, coming out of the gas cap,
modifying these data compromises the functioning and is reserved for authorized
technicians.
To see the next page, press “DOWN”
PAGE 2
to scroll the page press “ENTER”
Displays the percentage of gas dispersed in the environment, can be expressed in:
% of LEL or in ppm. In case of failure appears only “FAULT”
Displays the type of gas for which the probe has been calibrated
To see the next page, press “DOWN”
PAGE 3
PRINT to print, point the IR transmitter toward the printer and press “ENTER”
PAGE 4
Modification: “OFFSET” changes the deviation of the value of zero defined during
calibration.
PAGE 5
Modification: “TAR” multiplicative factor depending on the type of gas.
Printer recommended
BEINAT S.r.l. recommend a printer with infrared receiving 8 bits (1 start, error 4) Infrared
940nm, 33 kHz
Every time you disconnect the tester from the probe appears “PRINT”.
The TS1008 has loaded in memory the data stored in the probe and asked to print them.
If you do not want to print, turn off the tester or connect it to another probe.
