Installation
3. Make sure that the mounting surface of the cutout is smooth and cleaned from
any burrs or debris.
4. Install the operator panel into the cutout.
5. Secure the operator panel in position by screwing the slotted thumb screw
clockwise, allowing the built-in bracket to flip out and tighten against the
cabinet as shown.
Tighten the screws to 0.7 Nm ± 0.2 Nm.
6. In cases where the front panel seal (IP54 or greater, NEMA-4X) is critical,
use a torque wrench to ensure all screws are torqued within the specification
above.
Beijer Electronics, MAEN228
11
