Programmable I/O (PIO) NA-9379, Basic setting
KI00341
2014-10
•
The new IP-adress must be set within this time “one minute”
- Click on “Add New Device”
- Set IP address, Subnet Mask and gateway
- Restart the PIO
- When the MAC address is shown, click on ”OK”
Note!
If you “Add New Device” after “one minute” you have to
power OFF/ON. Then the PIO take the new setting.
Note!
Changing the IP can be made in a different way, such as:
- Click on “Start BootP”, Power on the PIO and Double click
at the MAC address.
- Write the new IP address and click on OK.
•
Check IP address with the “Ping”
Note!
IP address can also be checked via the port for Modbus RTU / Slave.
- Use IOGuidePro and "Protocol Messenger / Modbus"
- Standard RS-232 (straight cable) can be used
Link to
Adapter Address
www.beijer.se
8 (35)
K
I_eng_130531.
dot
, 070221
